Four details are enough to pick the right car battery, and all four are on the battery already fitted. You do not need to be a mechanic: you need a tape measure and two minutes with the bonnet open.
The four details that decide
- Case size. Length, width and height in millimetres. The tray is what it is: a longer battery will not fit and a lower one may sit loose in its clamp.
- Side of the positive terminal. With the terminals facing you, check whether the positive (+) is on the right or on the left. Swap sides and the cables will not reach.
- Capacity and cranking power. Amp hours (Ah) and cold cranking amps (A). The same figure or a little higher is fine; clearly lower will struggle in winter.
- Technology. Standard, EFB or AGM. A car with start-stop needs EFB or AGM. See AGM, EFB or standard.
Where to look
The label on the current battery shows capacity, cranking amps and nearly always a short maker’s code such as E11 or EA770. That code makes the search direct. If the label is unreadable, the owner’s manual gives the recommended capacity and you take the measurements yourself.
Step by step
- Note the code on the label, the Ah and the A.
- Measure the length, width and height of the case.
- Check which side the positive terminal is on.
- Check whether the car has start-stop.
- Look for that part number or an equivalent in the equivalence table.
The most common mistakes
- Choosing by amp hours alone and forgetting the size.
- Fitting a standard battery in a start-stop car: it lasts months, not years.
- Ignoring the height: there are 175 mm and 190 mm cases with the same length and width.
- Getting the polarity wrong by looking at the battery from the opposite side.
With the four details in hand, go to car batteries or, if your engine stops at traffic lights, to start-stop batteries.