Exide EB14-B2: motorbike and ATV starter battery 14Ah 12V 145A
The Exide EB14-B2: a battery for motorcycles and quads. Terminals of the M08 type.
- Voltage: 12V
- Amp-hours at C20: 14Ah
- Cold cranking amps: 145A
- Outer measurements: 135 × 90 × 165 mm
- Technology: Lead-acid
At a glance: Short version: Exide EB14-B2, made for motorcycles and quads, with a rating of 14Ah 12V 145A. Measure twice, order once: dimensions decide most swaps.
Practical advice for motorcycles and quads
Quads used for feeding livestock start on cold mornings. Fill a dry-charged battery cell by cell with its own acid and let it rest before charging. A battery that needs charging after every week parked is ready for replacement.
Measurements, ratings and codes
How lead-acid batteries work and how to look after them
Charging reverses the chemistry and restores the plates. Flooded deep-cycle batteries give good value in solar and traction work. Check acid levels regularly on serviceable batteries.
Same size and layout
Same format, different makers: these alternatives match the Exide EB14-B2 in size and layout.
Exide EB14-A2Varta YB14-A2Varta YB14-B2Fulbat FB14-A2Fulbat FTX14AH-BS / FB14-A2/B2 GEL
Questions buyers ask about the Exide EB14-B2
Is the Exide EB14-B2 part of a wider range?
It belongs to the EXIDE MOTORCYCLE CONVENTIONAL 12V line from Exide. Other models in the same line share the construction and differ mainly in size and capacity.
Does the Exide EB14-B2 have an EAN?
Its EAN code is 3661024033411. You can use it to confirm you are looking at exactly the same product as the one on your invoice or packaging.
Is the Exide EB14-B2 right for you?
Spotted Exide EB14-B2 on your old battery? That code is the one to use. With the positive on the left-hand side, the leads on most bikes that used this code fall into place. The Exide EB14-B2 page sets out the details before any panel comes off.
Most batteries for motorcycles and quads land close to 14Ah, and this one does too.
More options
You will find this battery in the motorcycles and quads section of baterias.online, ready to order. If in doubt about the fit, compare once more with the figures above.
Before you order: a quick checklist
- ✓ Some equipment needs adapters for M08 terminals.
- ✓ A different chemistry from lead-acid may need system changes.
- ✓ Dimensions to compare: 135 × 90 × 165 mm. Do not forget the base ledge, which the hold-down clamp grips on many vehicles.
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent