Trojan J250P battery for motive power and work machines, rated 250Ah 6V

In short: Spec sheet headline for the Trojan J250P: 250Ah 6V, made with traction and industrial equipment in mind. Every figure that decides the fit is in the table below.

Practical advice for traction and industrial equipment

Scissor lifts on a building site may sit idle for days, then work flat out. Check cable connections for tightness monthly. After many years of daily use, every traction set needs renewing.

Trojan J250P data sheet

lead-acid: how it works

Six cells of about two volts each make up a typical 12-volt battery. Starting engines is the classic job for a lead-acid battery. Recycle old batteries at an authorised point.

Questions buyers ask about the Trojan J250P

Trojan J250P for traction and industrial equipment

Pallet trucks, scissor lifts and floor cleaners often depend on a Trojan J250P. Rated 250Ah 6V, it matches machines designed around this code. Once the code matches, ordering at baterias.online takes a few minutes.

250Ah sits in the comfortable middle for traction and industrial equipment.

Related products and ranges

Happy with the fit? Ordering the Trojan J250P at baterias.online is quick. Checking the terminal side takes ten seconds and saves a lot of bother.

• More for traction and industrial equipment
• More from Trojan

Make sure it fits your vehicle or equipment

• ✓ Outside dimensions are 295 × 178 × 292 mm. Run a tape measure over your tray or compartment, including the height under the bonnet or lid.
• ✓ The capacity rating, 250Ah, should suit the consumers you run. Lots of electrical equipment calls for the higher end.
• ✓ Chemistry: lead-acid. Some vehicles and chargers are programmed for a specific type, so check before swapping.